A drawback is of you have a key connected to the 7300, you won't have the same cw speed control as n1mm. ![]() I don't have the exact configuration in front of me but it is doable. The setting is on my 7300 single cable post but matching n1mm keying settings to what you set on the radio will generate keying In the 7300 you can specify which signal you want to generate cw. I'll go back to both Commander/Winwarbler and N1MM and fiddle a bit more. My first goal is to try and achieve CW via CAT command and the 7300 is listed as capable of that (since it can do that via the internal key also). I'll try that later but that appears to require a few VSP's to be installed. To: Re: CW keying an Icom 7300 via N1MM?ĬJ, I read your post and that looks like the use of CW by setting the Icom internal menu (Connectors/USB Keying) to either RTS or DTR. The radio will switch to TX if semi-break in keying is enabled. In Configurer, there should be only one checkmark in the CW/Other column. There is no need to check "radio command PTT for CW". ![]() Set the DTR dropdown to CW and if you configured the radio above, the RTS dropdown to PTT. In N1MM Logger Configurer, open the radio COM port setup window. Using the radio SET menu configure DTR for CW.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |